Canon MP and IP paper jam

Printer doesn’t take paper :
1.Open your printer.
2.At the mechanic part printer (usually a set,
the located below roller and paper tray) there is wheel with pegas.
3.Usually the wheels is not on (hold by long iron like needle).
4.If the wheels are off, you just put back.
5.But when the spring (in the) wheels is corrupt,
structure is usually a mess,is not round at all.
6.You can cut the spring a maximum of 50% of the existing spring.
7.This spring functioning to set the direction of rotation only.
If the spring is too little, then the round will occur in both directions,
if the two directions can not be used.
8.If you can not cut forced find kanibalan from another printer.

Canon MP and IP series rather interesting all the papers
As roller penarik kertas. This is the cheap way
1.Pack up your printer cover (up to how to do, which is important not destroyed)
2.Usually broken the top, near the paper tray, you will find roller drawer paper.
3.Watch as these roller, must be broken.


4.first offthe roller, so u can do it.
5.At fault as the former, make a hole inside approximately 5 mm
by using a drill the smallest, or if you have a drill ga may also
use sharp metal.
6.Find the screw about the size of .
7.Place the screws are in the hole that was made,
then break the screw head with pliers cut,
so you can go into the holder as.
8.Before you install, make sure the fault is found so as not
entered into the printer.
9. If you're satisfied, raft back your printer, and print test your printer.