E602
1) Are the connection and the cable of the connector (J1017) on the main controller PCB and the connector (J1551) on the hard disk drive normal? NO: Correct the cable connection.Hard disk drive (HDD), Main controller PCB
2) Try replacing the hard disk drive and downloading the system software.Is the problem corrected?
YES: End. NO: Replace the main controller PCB.
3) HDD unit.
Remove the rear upper cover and the reader rear cover. Remove the three screws, and detach the cover, Remove the two screws and disconnect the two connectors then, remove the HDD unit. Remove the six screws and detach the HDD When mounting the HDD unit,be sure that the flat cable is under the plastic sheet of the HDD upper case.
Solution 1# :
It can be a Sector Problem ,to resolve it just press 1&9 keys at the same time the machine started the HD Diagonose and it repared the sector error without replacing the HDD .
Solution 2# :
try to go in to disc check service mode to clear the sectors ,this should work if it doesnt you will need to replace the hard drive .
Solution 3# :
Try HD clear & then HD check for every sector in service mode. Then try to upgrade system software;If nothing works change hard disk ,format & install system software.
* try holding down 1&9 on boot up or try reloading firmware with service support tool. If that don't work replace HDD with new one and reload firmware. If you get the new type HDD make sure you format it with the v15 format data file then reload, system,language and rui.
ReplyDeleteCanon ir2200 error code is E0602-03
ReplyDeleteError code CANON iR2200 / iR2800 / iR3300 / IR3100
ReplyDeleteE000
0000
The reading of the main thermistor does not reach 30°C 1 sec after the main power switch is turned on. Or, it does not reach 70°C 2 sec thereafter.
E001
0000
The main thermistor detects 250°C or higher.
0001
The main thermistor or the sub thermistor detects overheating (hardware circuit detection).
0002
The sub thermistor detects about 295°C or higher.
E002
0000
The temperature of the fixing film is as follows:
· has exceeded 100°C, but does not reach 115°C within 1 sec thereafter.
· has exceeded 140°C, but does not reach 150°C within 1 sec thereafter.
· has exceeded 160°C, but does not reach 165°C within 1 sec thereafter.
E003
0000
The main thermistor reading is lower than 140°C when paper is moved.
0001
Low fixing temperature detection after standby (by sub thermistor)
E007
0000
An error in the rotation of the fixing film is detected.
The reading of the main thermistor is 100°C or higher and, in addition, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing motor is driven.
E010
0000
After the main motor drive signal is generated, the clock signal does to arrive within 1.3 sec.
canon IR5000 error code e350
ReplyDeleteI have seach in the service manual, but there is not e350.
Somebody please help me.
thanks
It is related to the Serial Number PCB. Please check J1023 on the Main Controller to see if the PCB connector is loose. If you have recently replaced the Main Controller, retrace your steps and put anything back you may have forgotten or swapped. If the board has failed, good luck. You will have to go back to Canon and plead your case to get a replacement and I would guess it is not cheap. Let us know how you make out.
ReplyDeleteE350•Faults on serial number (SN) PCB-A check is made at power-on.
ReplyDelete