Comments on Do it yourself Inkjet and Laser Printer Repair: error code 602-0003 IR5000

E350•Faults on serial number (SN) PCB-A check is m...

2010-02-19T21:20:46.995-08:00

E350•Faults on serial number (SN) PCB-A check is made at power-on.

It is related to the Serial Number PCB. Please che...

2010-02-19T21:16:53.894-08:00

It is related to the Serial Number PCB. Please check J1023 on the Main Controller to see if the PCB connector is loose. If you have recently replaced the Main Controller, retrace your steps and put anything back you may have forgotten or swapped. If the board has failed, good luck. You will have to go back to Canon and plead your case to get a replacement and I would guess it is not cheap. Let us know how you make out.

canon IR5000 error code e350 I have seach in ...

2010-02-19T21:16:33.400-08:00

canon IR5000 error code e350

I have seach in the service manual, but there is not e350.
Somebody please help me.
thanks

Error code CANON iR2200 / iR2800 / iR3300 / IR3100...

2010-01-28T06:20:22.084-08:00

Error code CANON iR2200 / iR2800 / iR3300 / IR3100

E000
0000
The reading of the main thermistor does not reach 30°C 1 sec after the main power switch is turned on. Or, it does not reach 70°C 2 sec thereafter.
E001
0000
The main thermistor detects 250°C or higher.
0001
The main thermistor or the sub thermistor detects overheating (hardware circuit detection).
0002
The sub thermistor detects about 295°C or higher.
E002
0000
The temperature of the fixing film is as follows:
· has exceeded 100°C, but does not reach 115°C within 1 sec thereafter.
· has exceeded 140°C, but does not reach 150°C within 1 sec thereafter.
· has exceeded 160°C, but does not reach 165°C within 1 sec thereafter.
E003
0000
The main thermistor reading is lower than 140°C when paper is moved.
0001
Low fixing temperature detection after standby (by sub thermistor)
E007
0000
An error in the rotation of the fixing film is detected.
The reading of the main thermistor is 100°C or higher and, in addition, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing motor is driven.
E010
0000
After the main motor drive signal is generated, the clock signal does to arrive within 1.3 sec.

Canon ir2200 error code is E0602-03

2010-01-28T06:18:56.730-08:00

Canon ir2200 error code is E0602-03

* try holding down 1&9 on boot up or try reloa...

2010-01-28T06:15:24.499-08:00

* try holding down 1&9 on boot up or try reloading firmware with service support tool. If that don't work replace HDD with new one and reload firmware. If you get the new type HDD make sure you format it with the v15 format data file then reload, system,language and rui.